2.1.2. Power Connections
LINE:
The model 3410 Multivert has one or two (redundant supply is optional) universal power
supplies that operate on either 115 Volt / 60 Hz or 230 Volt / 50 Hz AC. The PSU STATUS
LEDs on the front panel indicate if the power supplies are operating normally.
2.2.
MOUNTING
The Multivert is equipped with rack mounting angles and fits into a standard 19 inches by 1.75 inches
by 7.75 inches (483 mm x 45 mm x 196mm) rack space. The mounting angles may be removed and
installed from the rear if mounting at the back of an equipment rack is desired. For front mount
applications, a rear support bracket (part 3400RS) can be ordered if additional support is required due
to the weight of the cables. Figure 4 and Figure 5 show the two methods of mounting the Multivert in
your rack frame.
!
It is recommended that at least ½ rack unit space be left between the Multivert
and adjacent units to allow for airflow required for convection cooling.
Figure 4: Front Mounting
Revision 1.2
Model 3410 Multivert Manual
Page 3