Table of Contents
Advertisement
WAVE SAMPLING
Touch the WAVE SAMPLING button and then touch the OK
button. If a comparison waveform has been saved in the current
work, it will be shown. If not, the following screen will open.
1
Touch the + button to start measurement.
NOTE
o The measured value is shown in the middle of the
Y axis.
o Touch the + button again during waveform sam-
pling to stop sampling at that point.
2
After measurement, touch the OK button to save
the waveform.
This will open the comparison waveform editing screen.
o Touch the – button to redo measurement.
Editing comparison waveforms
1
Touch the beginning position of the comparison
waveform to show the cursor, and touch the g
button to remove the unnecessary part.
2
Touch the ending position of the comparison wave-
form to show the cursor, and touch the t button
to remove the unnecessary part. Then, touch the
OK button.
3
Move the comparison waveform to the desired
position.
Follow the operation procedures at the bottom of the
screen to move the comparison waveform.
NOTE
The offset positions of the high and low limits relative to
the reference values are shown in the middle of the Y axis.
4
Touch the OK button to save the waveform, and
touch the ESC button twice to close the screen.
4. Settings
47
Advertisement
Chapters
Table of Contents
