Zooming The Waveform Display In/Out; Buttons And Their Functions - KYOWA WP-120A Instructions For Use Manual

1. Names and functions of parts
1-3-3. Zooming the waveform display
in/out
On the waveform display screen, touch the ¥ button to open
the GRAPH SCALE CHANGE SCREEN.
o This only increases/decreases the scale of the load waveform.
5, b
Change the maximum value of the Y axis.
g, t
Change the full-scale value of the X axis.
−, +
Change the minimum value of the Y axis.
NOTE
Setting a negative value will move the starting point up,
enabling negative value waveforms to be shown.
OK
Confirm the settings and return to the waveform display
screen.
ESC
Cancel the settings and return to the waveform display screen.
Default
Restore the default settings for waveform display.
14

1-4. Buttons and their functions

Button
Digital zero (page 15).
Open SETTINGS screen (page 27).
Show measurement results
(page 15).
Open SENSOR MEMORY/WORK
NUMBER screen (page 17)
Save screenshots and measure-
ment results on SD cards.
The icon shows the SD card status
(page 17).
Touch to switch between indicator
value and waveform display.
Reset the hold status.
Touch during measurement to
cancel measurement.
Manually start and stop
measurement.
Zoom the waveform display in/out
(page 14).
Touch a load indicator value on the
waveform display to open the LOAD
CELL screen (page 40).
Touch a displacement indicator
value on the waveform display to
open the DISPLACE. SENSOR screen
(page 41)
Reset the OK and NG counters.
Reset peak and bottom values.
Set the comparison values for con-
tinuous judgment (page 45).
Function