KYOWA WP-120A Instructions For Use Manual page 81

6-1-4-3. Measurement result polling (0007)
If the measurement status of the unit is "Stop", the status and current judgment result will be returned. If the measurement status of
the unit is anything else, only the status will be returned.
Command
HEX 0×23 0×30 0×30 0×30 0×30 0×30 0×37 0×32 0×37 0×0D
ASCII # 0 0
Fixed
Responses
When the measurement status of the unit is "Stop"
Byte 0 1 2
HEX 0×06 0×30 0×30 0×30 0×30 0×30 0×37
ASCII ACK 0 0
Fixed
Byte 19 20 21 22
HEX 0×2c
ASCII LOAD DISP , LOAD DISP
Zone 2
judgment judgment
When the measurement status of the unit is not "Stop"
Byte 0 1 2
HEX 0×06 0×30 0×30 0×30 0×30 0×30 0×35
ASCII ACK 0 0
Fixed
Status
CHECK (measurement complete condition)
0: No, 1: Check
o This becomes 1 when measurement completes and becomes 0 after reading once.
ST1 (command status)
0: Ready, 1: Busy, 2: Error, 3: continuous transmission active, 4: sending results automatically
ST2 (measurement status)
0: Continue, 1: Wait, 2: Rec, 3: Stop
Judgment
TOTAL (overall judgment), LOAD (load judgment), DISP (displacement judgment), BAND (band judgment)
0: NO, 1: OK, 2: LL, 3: LO, 4: HI, 5: HH, 6: HL, 7: NG, 8: FULL, 9: OVER
Zone 1–5 judgments
LOAD (load judgment), DISP (displacement judgment)
0: NO, 1: OK, 3: LO, 4: HI, 7: NG
0 0 0 7 2
Command No. Checksum
3 4 5 6 7
0 0 0 7 CHECK ST1
Command No.
23 24 25 26
0×2c
, LOAD DISP
Zone 3 Zone 4
judgment
3 4 5 6 7
0 0 0 5 ST1
Command No.
7 CR
8 9 10 11 12
ST2 TOTAL LOAD DISP
Status Judgment
27 28 29 30 31
0×2c
, LOAD DISP ×
Zone 5
Checksum
judgment
8 9 17 18 19
0×0D 0×0A
ST2 ST3 × × CR
Status Checksum
6. Communication functions
13 14 15 16
0×2c 0×2c
, BAND , LOAD DISP
Zone 1
judgment
32 33
0×0D 0×0A
× CR LF
20
LF
17 18
0×2c
,
81