Current Band Wave & Multi-Zone; Arrangement Screen; Start/Stop Measurement; Ment - KYOWA WP-120A Instructions For Use Manual

4-5-5. CURRENT BAND WAVE & MULTI-
ZONE ARRANGEMENT screen
Touch the waveform display area on the waveform display
screen to open the CURRENT BAND WAVE & MULTI-ZONE

ARRANGEMENT screen.

Touch below the X axis to open the WORK settings screen.
Displaying and moving bands and spe-
cific zones
Touch the button of an item to be shown or moved to show
only the range of that item
ZONE 2 has been selected in the example below.
Use the 5bgt buttons to move the zone in the desired
direction.

4-6. Start/stop measurement

In the following explanation, operation is for when EXT. START/
STOP has been set to "EDGE" (page 26).
4-6-1. Measurement start/stop settings
for zone judgment
Touch the buttons in the following order on the Home Screen
to open the settings screen.
WORK
e
When the work settings screen opens, touch a button
below "COND. " or "LEVEL" to set the method to start or stop
measurement.
NOTE
Use control signal input terminal number 35 (start/stop mea-
surement) of the CONTROL connector to control measurement
starting and stopping (page 25).
4-6-1-1. Measurement starting settings
EXT. SIGNAL
Measurement starts when an external signal becomes on or
when the waveform display START button is touched. See
"4-6-4. Zone judgment timing chart" on page 56 for details.
EXT. & LOAD
After an external signal start condition is realized, measure-
ment will start when the load exceeds the start level (AND
condition).
Load
Starting level
Start/stop measurement
Start/stop
OFF
ON
4. Settings
q
Start measurement
53