Installation - KYOWA WP-120A Instructions For Use Manual

Follow these procedures to install the WP-120A in a control
panel.
1
Open a hole in the panel in accordance with this
dimensional drawing of the panel installation
opening.
Panel installation opening
dimensions
Recommended panel
thickness: 1.6–3.2 mm
92
2
Remove the screws in two locations. Then, remove
the left and right guide rails.
Guide rail
3
Insert the WP-120A through the front of the panel.
+1
0
Guide rail
Screws
4
From the back, attach the guide rails removed in
step 2 and secure them using screws in two places.
(Recommended tightening torque: 0.5 N·m ≈ 5.1 kgf·cm)
o Do not use any screws other than those included
with the WP-120A.

2. Installation

19