KYOWA WP-120A Instructions For Use Manual page 38

4. Settings
4-3-3-2. TEDS loading
After loading the TEDS data, the rated output/rated capacity
is shown.
Rated capacity digit shown during TEDS calibration
TEDS sensor
Rated capacity
value
1
2
3
4
5
10
20
30
40
50
100
200
300
400
500
NOTE
o TEDS data is automatically loaded when the power is
turned on.
o After TEDS data is loaded once, it will not be loaded auto-
matically again until a different TEDS sensor is connected.
If you want to load it again, manually execute "TEDS CALIB. "
o The decimal point position for the rated capacity will be
used as the decimal point position for the indicator value.
o The maximum display value (Max. disp. value) is set as 110%
of the rated capacity.
ATTENTION
The bridge voltage will be set to a value that is less than the
maximum safe excitation voltage stored in the TEDS memory.
38
Indicator
Unit
value
N, kN 01.000
N, kN 02.000
N, kN 03.000
N, kN 04.000
N, kN 05.000
N, kN 010.00
N, kN 020.00
N, kN 030.00
N, kN 040.00
N, kN 050.00
N, kN 0100.0
N, kN 0200.0
N, kN 0300.0
N, kN 0400.0
N, kN 0500.0
4-3-3-3. ZERO BALANING
With no load on the sensor, touch the EXECUTE button.
o If a calibration error appears, conduct countermeasures
according to the error message, and redo calibration.
4-3-3-4. UNIT SHOWN
Select the unit that corresponds to the indicator value from
the list, and touch the OK button.
NOTE
o The unit shown is next to the indicator value, but it has no
effect on internal calculations.
For example, the calibration value will not change even if
the unit shown is changed from "N" to "kN".
o If a sensor with TEDS built in is connected, the read unit
will be set.
4-3-3-5. TEDS DATA DISPLAY
Select TEDS DATA DISPLAY to show the following items.
MANUFACTURER
MODEL NUMBER
VERSION
SERIAL NUMBER
RATED OUTPUT
RATED CAPACITY
UNIT SHOWN
SENSOR IMPEDANCE
MAX. EXCITATION LEVEL
CAL. DATE
Touch the ESC button to exit TEDS data display mode.