KYOWA WP-120A Instructions For Use Manual page 49

4-5-3-2. Setting examples
For details about each setting item, refer to the following
explanations.
Peak hold
This explanation uses settings for conducting peak holds with
multi-zone judgment as an example. (A displacement sensor is
not used in this example.)
Touch the buttons in the following order on the Home Screen
to open the settings screen.
WORK ZONE JUDGMENT
e e
a
ZONE SWITCHING
Select PRESET.
NOTE
Holds will occur when measurement values are in the
zone.
b
Zone
Select 1.
NOTE
Any number from 1 to 5 can be selected.
c
Zone 1
Select ENABLE.
NOTE
The judgment method will be conducted simultaneously
for enabled zones, so be sure that unneeded zones are
not enabled.
d
Indicator value display
Select ZONE 1.
NOTE
This shows ZONE 1 hold values after measurement.
e
JUDGE. METHOD (judgment method)
Select PEAK.
f
ZONE RANGE
Select 0.700–1.400 s.
NOTE
After starting measurement, peak holds will be con-
ducted for 0.700–1.400 seconds.
To conduct peak holds for the time between measure-
ment start and finish, set the 0–X axis full scale value
(page 29).
g
LOAD HIGH (HI)/LOW (LO)
Select 40.00–10.00 N.
NOTE
Set the range for OK judgment.
h
DISPLACEMENT (HI)/(LO)
This is not used.
The results measured with the above settings will be as follows.
i
Hold position
NOTE
This is the peak hold point with these settings.
j
Zone range display
The range designated with the ZONE RANGE setting
and the LOAD HIGH (HI)/LOW (LO) limits is shown with
a rectangle.
k
Load indicator value
NOTE
This shows the peak value with these settings.
4. Settings
49