KYOWA WP-120A Instructions For Use Manual page 61

4-6-4-2-7. Maximum/minimum
The maximum and minimum load values are detected when measurement values are in the zone.
At the moment that the load difference × scaling factor occurs the number of times set for the detection count, the points when the
maximum and minimum values occurred will become the hold points.
Load
Judgment output (load/displacement)
OFF
HI
ON
OFF
LO
ON
Judgment output (load/displacement)
If the hold point meets a HI or LO condition, this becomes ON.
If the hold point is within the management value range, judgment for this zone will be OK.
Maximum Minimum
Load
difference
Zone interval
Load difference × scaling factor,
detection count realized
Time or displacement
4. Settings
61