KYOWA WP-120A Instructions For Use Manual page 84

6. Communication functions
6-1-4-5. Read hold value (0010)
If the measurement status of the unit is "Stop", the status and hold value will be returned. If the measurement status of the unit is any-
thing else, an error (NAK) will be returned.
Command
HEX 0×23 0×30 0×30 0×30 0×30 0×31 0×30 0×30 0×30
ASCII # 0 0
Fixed
Data
START
Measurement result that starts transmission
0: Band judgment, 1–5: Zone number
STOP
Measurement result that ends transmission
0: Band judgment, 1–5: Zone number
NOTE
o The transmission order is Band judgment, Zone 1 judgment, Zone 2 judgment, Zone 3 judgment, Zone 4 judgment, Zone 5
judgment.
o The judgments will be separated by commas.
Responses
Example of measurement result response when the measurement status of the unit is "Stop" (START: 0, STOP: 1)
Byte 0 1 2
HEX 0×06 0×30 0×30 0×30 0×30 0×31 0×30 0×2c
ASCII ACK 0 0
Fixed
Band/zone judgment format
Byte +0 +1 +2 +3
HEX 0×2c
ASCII J_L , ± ×
Load value (including decimal places)
*This is time (ms) if the X axis is a time setting or a displacement value if the X axis is a displacement setting
J_L (load judgment), J_D (displacement judgment)
0: NO, 1: OK, 2: LL, 3: LO, 4: HI, 5: HH, 6: HL, 7: NG, 8: FULL, 9: OVER
When the measurement status of the unit is not "Stop"
Byte 0 1 2
HEX 0×15 0x30 0x30 0x31 0x30 0x0D 0x0A
ASCII NAK 0 0
84
0 0 1 0 START STOP
Command No. Data
3 4 5 6 7
0 0 1 0 ,
Command No.
+4 +5 +6 +7 +8
× × × × ×
3 4 5 6
1 0 CR LF
0×0D
× × CR
Checksum
8–26 27
0×2c
Load,
,
displacement
Band judgment Zone 1 judgment
+9 +10 +11 +12 +13 +14 +15 +16 +17 +18
0×2c 0×2c
, J_D , ± ×
Time or displacement value*
(including decimal places)
28–46 47 48
Load,
× ×
displacement
Checksum
× × × × ×
49 50
0×0D 0×0A
CR LF