Table of Contents
Advertisement
7.2
Parameter Setting List
This section lists the parameter setting items for the L series master/local module and whether the settings are
required for each station.
Item
Number of Modules
Start I/O No.
Parameter Name
Data Link Faulty Station Setting
Case of CPU STOP Setting
Connected Devices Auto-detection
Operation
Setting
Number of Occupied Stations
Expanded Cyclic Setting
Block Data Assurance per Station
Type
Station No.
Master Station Data Link Type
Mode
Transmission Speed
Total Module Connected
Remote Input(RX)
Remote Output(RY)
Remote Register(RWr)
Remote Register(RWw)
Ver.2 Remote Input(RX)
Ver.2 Remote Output(RY)
Ver.2 Remote Register(RWr)
Ver.2 Remote Register(RWw)
Special Relay(SB)
Special Register(SW)
Retry Count
Automatic Reconnection Station Count
Standby Master Station No.
74
: The setting is available. : The setting is required if necessary. : The setting is not available.
Necessity of the setting
Local station,
Master
station
master station
standby
Set the setting only when "Remote Net(Ver.1
Mode)", "Remote Net(Ver.2 Mode)" or "Remote
Net (Additional Mode)" is set in "Mode".
Set the setting only when "Remote Net(Ver.2
Mode)" or "Remote Net (Additional Mode)" is set
in "Mode".
The setting is automatically input when "Station
Type" is set in the CC-Link configuration window.
The setting is automatically input when "Station
Type" is set in the CC-Link configuration window.
The setting is automatically input when "Station
Type" is set in the CC-Link configuration window.
Set the setting only when "Remote Net
(Additional Mode)" is set in "Mode".
The settings are not required when "Remote I/O
Net Mode" is set in "Mode".
• The setting is automatically input when the
standby master station is set in the CC-Link
configuration window.
• The setting is not required when "Remote I/O
Net Mode" is set in "Mode".
Remark
Advertisement
Table of Contents
Troubleshooting
