Mitsubishi Electric L26CPU-BT User Manual page 80

Item
Select "Master Station".
To configure the system that switches the control to
the standby master station if the master station goes
down, set as follows.
When a failed master station
becomes normal again, it does
not return as a standby master
Type
station.
Station No. Set the station number of the module.
Master Station Data Link "PLC Parameter Auto Start" is displayed. (The setting
Type is not required.)
Select the mode of the L series master/local module.
(Refer to
If the mode is selected in the CC-Link configuration
Mode
window for the station information setting, the mode
selected in the CC-Link configuration window is
automatically set.
Transmission Speed Set the transmission speed of a module.
Set the number of device station (including a reserved
station) to connect. If "Set the station information in
Total Module Connected the CC-Link configuration window" is selected, the
setting is automatically input by configuring "Station
Information Setting".
78
Description
Operation
• When a failed master station
becomes normal again, it
returns as a standby master
station.
• When only the standby
master station is started up, it
starts data link as a master
station.
Page 35, Section 3.4.)
Setting
Master Station
• Master Station
• Master Station (Duplex Function)
(Default: Master Station)
Master Station
(Duplex Function)
• Master Station: 0
• Master Station (Duplex Function): 0 to 64
(Default: 0)
• Remote Net(Ver.1 Mode)
• Remote Net(Ver.2 Mode)
• Remote Net(Additional Mode)
• Remote I/O Net Mode
• Offline
• Loop Test
• H/W Test
(Default: Remote Net(Ver.1 Mode))
• 156kbps
• 625kbps
• 2.5Mbps
• 5Mbps
• 10Mbps
(Default: 156kbps)
1 to 64 (Default: 64)
Setting range
