Table of Contents
Advertisement
[Select modules in "Module List" and drag and drop them to "List of stations"]
1. Open the CC-Link configuration window.
Project window
button
2. Select modules in "Module List" and drag and drop them to "List of stations".
Device stations are added to "List of stations". The added modules are displayed in the device map area
as well.
3. When the setting is completed, close the CC-Link configuration window by clicking [Close with Reflecting
the Setting].
Item
Mode Setting
Select the mode of a master station. (Refer to
TX Speed
Select the transmission speed of a master station.
Link Scan Time
The estimate value of link scan time is displayed.
(Approx.)
• For a master station
0/0 is displayed.
Station No.
• For a device station
The order of the device station is displayed before the slash.
The start station number of the device station is displayed after the slash.
The model name of the module is displayed.
Model Name
If the module information cannot be found, "Module without profile" is
displayed.
Select the station type. Set the station type of the device station actually
Station Type
connected.
[Parameter]
[Network Parameter]
Description
CHAPTER 7 PARAMETER SETTINGS
[CC-Link]
[CC-Link Configuration Setting]
• Ver.1 Mode
• Ver.2 Mode
• Addition Mode
Page 35, Section 3.4.)
• Remote I/O Mode
(Default: Ver.1 Mode)
• 156kbps
• 625kbps
• 2.5Mbps
• 5Mbps
• 10Mbps
(Default: 156kbps)
Varies depending on the module
that was set.
7
Setting range
85
Advertisement
Table of Contents
Troubleshooting
