Table of Contents
Advertisement
(4) Interrupt Settings
Project window
1. In the "Interrupt Settings" window, set the conditions on which the L series master/local module issues the
interrupt to a CPU module.
2. Click the [End] button and close the setting window.
Item
Input Format
Select the input format of "Word Device Setting Value".
Device Code
Set the device for the interrupt condition.
Device No.
Detection Method
Select the timing of the interrupt detection for the device set in "Device Code"
and "Device No."
Interrupt Condition
Word Device Setting
Set the word device value for the interrupt condition if RWr or SW is set in
Value
"Device Code".
Channel
The setting is not required for an L series master/local module.
No./Connection No.
Set the interrupt (SI) No. used for the interrupt pointer setting of the PLC
parameter.
Interrupt (SI) No.
The interrupt (SI) No. is the control number on the L series master/local
module side to issue a request for the interrupt from the L series master/local
module to a CPU module. (This is not a device used for an actual program.)
Only one interrupt condition can be set for one interrupt program.
[Parameter]
[Network Parameter]
Description
CHAPTER 7 PARAMETER SETTINGS
[CC-Link]
[Interrupt Settings] button
• DEC
• HEX
(Default: DEC)
Refer to the following table on
7
Setting range
the next page.
93
Advertisement
Table of Contents
Troubleshooting
