Table 3-7 Recommended Crimp Tools; Special Tools Required - Garmin GI 275 Installation Manual

3.1.3

Special Tools Required

The following tools are required for building the wire harness.
Milliohm Meter
A milliohm meter with an accuracy of ±0.1 milliohm (or better) to perform continuity and power/ground
checks.
Crimp Tool
A crimp tool meeting MIL specification M22520/2-01 and a positioner/locator are required to ensure
consistent, reliable crimp contact connections for the rear D-sub connectors. Refer to Table 3-7.
Hand
Manufacturer Crimping
Military P/N M22520/2-01
ITT Cannon 995-0001-584 995-0001-739
Positronic
AMP 601966-1
Daniels AFM8
Astro 615717
Non-Garmin part numbers shown are not maintained by Garmin and are subject to change without notice.
Notes:
[1] For configuration module pins, verify the crimp tool is set to crimp 28 AWG wire.
GSB 15 Installation
A crimp tool is required for the GSB 15 installation. The recommended crimp tool is Molex Hand Crimp
Tool (P/N 638190000). For other options, refer to GSB 15 Installation Manual (P/N 190-00303-A3).
190-02246-10
Rev. 11

Table 3-7 Recommended Crimp Tools

22-28 AWG
Positioner [1]
Tool
M22520/2-09
9507 N/A
601966-6
K42
615725
Insertion/
Positioner
Extraction Tool
M81969/14-01 M22520/2-08
N/A
N/A 9502-5
91067-1 601966-5
N/A K13-1
N/A 615724
GI 275 Part 23 AML STC Installation Manual
22-24 AWG
Insertion/
Extraction Tool
M81969/1-02
N/A N/A
M81969/1-02
91067-2
M81969/1-02
M81969/1-02
Page 3-6