Table 5-45 Airframe-Specific Configuration Data - Configuration Type Basic Setting - Garmin GI 275 Installation Manual

Table 5-45 Airframe-Specific Configuration Data – Configuration Type Basic Setting
Item
VS0 Stall speed in landing configuration
Stall speed in a specific flight
VS1
configuration
Vfe Maximum flap extended speed
Vno Normal operating speed
Vne Never exceed speed
GLIDE Glide speed
Vr Rotation speed
Vx Best angle of climb speed
Vy Best rate of climb speed
Maximum landing gear extended
Vle
speed
Minimum controllable airspeed for
Vmca twin-engine aircraft with only one
engine operational
Single engine best rate of climb
Vyse
speed for a twin-engine aircraft
Vne
Applicable to rotary wing aircraft only
(Pwr Off)
190-02246-10
Rev. 11
Description
AFM/POH
Reference
Section
2 - Limitations Bottom of white arc on ASI.
2 - Limitations Bottom of green arc on ASI.
Top of white arc on ASI; if more than one
2 - Limitations
flap speed is given, use the lowest speed.
Top of green arc/bottom of yellow arc on
ASI; if the aircraft has no yellow arc but has
2 - Limitations
a green arc that extends to the red radial, set
Vno to the same value as Vne.
2 - Limitations Red radial on ASI.
Optional.
3 - Emergency
Procedures
Set to 0 kt (off) if not listed in the AFM/POH.
Optional.
4 - Normal
Typically set to rotation speed.
Procedures
Set to 0 kt (off) if not listed in the AFM/POH.
Optional.
There are speeds listed for GEAR UP and
4 - Normal
GEAR DOWN; use the speed listed for
Procedures
GEAR DOWN.
Set to 0 kt (off) if not listed in AFM/POH.
Optional.
There are speeds listed for GEAR UP and
4 - Normal
GEAR DOWN; use the speed listed for
Procedures
GEAR UP.
Set to 0 kt (off) if not listed in the AFM/POH.
2 - Limitations Set to 0 kt (off) for fixed gear aircraft.
Lower red radial on ASI of light twins.
2 - Limitations
Set to 0 kt (off) for single engine aircraft.
3 - Emergency
Procedures
Blue radial on ASI of light twins.
OR
Set to 0 kt (off) for single engine aircraft.
4 - Normal
Procedures
N/A Set to OFF.
GI 275 Part 23 AML STC Installation Manual
Notes
Page 5-37