Figure B-5 Nav Interconnect - Garmin GI 275 Installation Manual

NOTES
FOR GNC NAVIGATORS, CONNECT ALL SHIELDS TO SHIELD BLOCK GROUND, NOT AIRFRAME GROUND.
1
THE NAV RECEIVER DOES NOT PROVIDE A VLOC COMPOSITE LO PIN. CONNECT THE VLOC COMPOSITE
2
LO WIRE FROM THE GDU TO GROUND AT THE NAV RECEIVER.
KX 170B / KX 175B DO NOT HAVE A GLIDESLOPE OUTPUT. USE A SEPARATE GLIDESLOPE RECEIVER TO
3
DRIVE THESE INPUTS ON THE GDU.
KX155/165 NAV UNITS HAVE DUAL GLIDESLOPE OUTPUTS. USE "NUMBERED" OR LETTERED PINS, NOT
4
BOTH. WHENEVER POSSIBLE, USE AN UNUSED SET OF PINS.
GLIDESLOPE CONNECTIONS ARE ONLY REQUIRED IF THE NAV RECEIVER CONTAINS THE OPTIONAL
5
GLIDESLOPE RECEIVER.
THE GTN 6XX/7XX AND GTN Xi UTILIZE THE SAME INTERFACE SHOWN IN THE GPS INTERCONNECT;
6
THEREFORE, NOT SHOWN IN THE NAV INTERCONNECT.
190-02246-10
Rev. 11

Figure B-5 NAV Interconnect

Sheet 2 of 2
GI 275 Part 23 AML STC Installation Manual
Page B-10