Analog Navigation Receiver; Table C-7 Compatible Analog Navigation Receiver - Garmin GI 275 Installation Manual

C.6 Analog Navigation Receiver
Interface to analog navigation receivers not listed in Table C-7 can still be approved under the GI 275 if all of the following conditions are met:
• The navigation receiver is approved to TSO C36( ) (Localizer), TSO C40( ) (VOR), and optionally TSO C34( ) (Glideslope) if the glideslope is used
• If the glideslope is being used, the navigation receiver has a glideslope low-level flag output
• The installation of the navigation receiver was previously FAA-approved
• The calibration procedure for the analog navigation receiver described in Section 5.7.3 and the ground check in Section 6.3.2.2 have successfully completed
NOTE
The GI 275 is an EZ zeroed resolver at 0 degrees.
Mfr Model
Collins VIR-32/33
GNS 4XX/5XX
GNS 4XXW/5XXW
Garmin
GTN 6XX/7XX
GTN Xi
KX 155/155A/165/165A
Honeywell
KN 53
(Bendix/King)
KX 170B/175B
190-02246-10
Rev. 11

Table C-7 Compatible Analog Navigation Receiver

Data Format Interfacing Equipment Configuration Information
Composite
Analog
Composite
Analog
Composite
Analog
Composite
Analog
Composite
Analog
Composite
Analog
Composite
Analog
Notes
Can be NAV 1, NAV 2, or both.
Can be NAV 1, NAV 2, or both.
This interface only supports
NAV, not GPS. It is
recommended to connect and
configure per Table C-6.
Can be NAV 1, NAV 2, or both.
GI 275 Part 23 AML STC Installation Manual
Page C-10