Figure 5-17 Page Config Page - Mfd/Standby Adi (Left) And Eis (Right); Page Configuration - Garmin GI 275 Installation Manual

5.5.3

Page Configuration

The Page Config page contains options that determine which pages will display in Normal mode based on
the primary function(s) of the specific display as configured on the Unit Configuration page (refer to
Section 5.3.4). Refer to Section 5.5.3.7 for an example of each page displayed in Normal mode.
In Configuration mode, navigate to the Setup → Page Config page, as shown in Figure 5-17. Some
instrument types contain optional pages that can be toggled on and off or pages that can be rearranged.
Instrument types that do not have configurable pages (i.e., Primary ADI) will have the Page Config button
grayed out.

Figure 5-17 Page Config Page - MFD/Standby ADI (Left) and EIS (Right)

5.5.3.1 Primary ADI Page Options
When a unit is configured as a Primary ADI, the ADI page must be displayed at all times; therefore, the
Page Config page will be grayed out. Figure 5-18 depicts possible ADI page styles as configured from the
Airframe Configuration page (refer to Section 5.5.1).
Attitude information is displayed in the form of a virtual blue sky and brown ground with a white horizon
line. The attitude indicator displays pitch, roll, and slip/skid information. The airspeed tape will be located
vertically on the left side of the display and the altitude tape will be located on the right side if configured
as a 3-in-1 or 4-in-1 ADI. Magnetic heading will be displayed horizontally on the bottom of display if
configured as a 4-in-1 ADI.
Figure 5-18 Primary ADI Page – Basic, 3-in-1, 4-in-1
190-02246-10 GI 275 Part 23 AML STC Installation Manual
Rev. 11 Page 5-46