Gi 275S Installed; Wireless - Garmin GI 275 Installation Manual

5.4.1

GI 275s Installed

The GI 275s Installed page is used to identify which GI 275s are installed as part of the system, allowing
data to be crossfilled between units via HSDB.
Verify the following for each installed GI 275:
• The Unit ID must be set and must be unique, as described in Section 5.3.1
• The the current assigned Unit ID for each display is denoted on the GI 275s Installed page by a
grayed out selection
Perform the following steps to configure the GI 275 system:
1. Power on all GI 275s in the system in Configuration mode.
2. Navigate to the GI 275s Installed page (Interfaces → GI 275s Installed).
3. Select the Unit ID for each GI 275 in the system.
4. Repeat step 2 and 3 on each GI 275 unit.
5. Once each unit's GI 275s Installed page has been configured, navigate to the Devices Online page
(System Info → Devices Online).
6. Ensure each Unit ID in the system shows a green square.
5.4.2

Wireless

The Wireless page allows you to connect the GI 275 unit to a Bluetooth connection or to generate a Wi-Fi
signal. Refer to Section 5.13 or GI 275 Pilot's Guide for more information on wireless functionality.
The Wi-Fi functionality should only be enabled on one Garmin LRU at a time.
190-02246-10
Rev. 11
GI 275 Part 23 AML STC Installation Manual
Page 5-11