Figure 5-27 Kfc 200 Test Port - Garmin GI 275 Installation Manual

6. Flight Director calibration:
a. Verify that the internal AHRS Pitch/Roll Outputs are zero and valid.
b. Navigate to the Flight Director Calibration page on the GI 275 (Calibration/Test →
Autopilot → Flight Director).
c. Disengage all AP/FD modes, then re-engage the FD only by pressing the FD button. The flight
director data on the GI 275 must be valid.
d. Adjust the Roll Command Bar Zero pot on the KC 295 computer until the FD Roll command
on the GI 275 is as close to 0.00° as possible.
e. Adjust the Pitch Command Bar Zero pot on the KC 295 computer until the FD Pitch command
on the GI 275 is as close to 0.00° as possible.
330-00360-00 CONNECTOR
(Tyco 206485-1)
PITCH REF
VERTICAL GYRO PITCH T.P.
GYRO ROLL CROSSFEED
LAT REF
ROLL ADJ
PITCH ADJ
KC 296
(YAW COMPUTER)
GYRO ROLL CROSSFEED
KC 290
(MODE CONTROLLER)
ROLL ADJ
PITCH ADJ
190-02246-10
Rev. 11
1
2
3
4
5
6
IF CONNECTED
P2961
H
LAT REF F
P2902
F
A

Figure 5-27 KFC 200 Test Port

<4"
P2952
L
P
X
f
K
b
GI 275 Part 23 AML STC Installation Manual
KC 295
PITCH REF
VERTICAL GYRO PITCH T.P.
GYRO ROLL CROSSFEED
LAT REF
ROLL ADJ
PITCH ADJ
Page 5-73