4.7.4
Oil Temperature
CAUTION
Severe engine damage may occur if the incorrect probe length or type is installed. Use the
engine manufacturer's guidance for proper oil temperature probe length and type.
When installing the oil temperature sensor, use the engine manufacturer's guidance for probe length and
location. The unbroken side of the crush washer must face the sensor flange. The sensor is torqued finger
tight plus one-half turn and safety wired in accordance with practices defined in Section 7, Safetying, of
Chapter 7, Aircraft Hardware, Control Cables and Turnbuckles, of AC 43.13-1B Aircraft Inspection and
Repair.
Figure 4-50 Oil Temperature Sensor Installation Example
190-02246-10
Rev. 11
GI 275 Part 23 AML STC Installation Manual
Page 4-68