External Flight Director; Table C-10 Compatible External Flight Director - Garmin GI 275 Installation Manual

C.9

External Flight Director

The flight directors listed in Table C-10 are compatible with the GI 275.
Mfr Model
Bendix M-4D
IV
Century
41
2000
300B IFCS/ 400B IFCS/
800B IFCS
Cessna
1000 IFCS
Collins AP-106/107
Garmin GFC 600
KFC 150/KFC 200/
KFC 225
Honeywell
KFC 250
(Bendix/King)
KFC 300
55/55X
S-TEC
60-2/65
(with ST-670)
Sperry SPZ-200A/500
Notes:
[1] FZ-500 flight director computer must be strapped for low gain pitch/roll steering and pitch/roll bias out of view inputs must be connected.
190-02246-10
Rev. 11

Table C-10 Compatible External Flight Director

Data Format Interfacing Equipment Configuration Information
5536F computer must have 4007463-0501 Flight Director Board
Analog
(for Collins 329B7-R, FD-108, and FD112C/V indicators).
Autopilot computer must be previously compatible with the single cue 52C77( )
Analog
series indicator.
Analog
Analog
Analog
Analog
OUT OF VIEW+ signal from autopilot must be inverted to be Active-High for
Analog
correct operation with the GI 275.
HSDB
For KFC 150, EFIS-enabled KC-19X computer (P/N 065-0042-16) is not
Analog
supported.
Analog
Analog
ST-645 Remote Annunciator panel must be installed (or retained) if the flight
director is displayed on GI 275. This will provide the required mode annunciations.
Only flight director pitch/roll outputs directly from 55X computer can be used for
Analog display on GI 275 (FD pitch/roll outputs from the remote annunciator panel cannot
be used).
If FD Logic output from 55X P2-4 is connected to P1-20 input on ST-645, it must
be disconnected.
ST-670 Single Cue FD Interface Unit for King KI 256 (P/N 01180) must be installed
Analog
or retained to display flight director information on the GI 275.
Analog
GI 275 Part 23 AML STC Installation Manual
Notes
[1]
Page C-15