Main Eis Page; Figure F-1 Example Main Eis Page; Figure F-2 Top Full-Time Gauge Examples - Garmin GI 275 Installation Manual

F.1 Main EIS Page
The Main EIS page is divided into four sections: top, bottom, middle-left, which contains a CHT/EGT
Graph, and middle-right, which contains strip gauges.
The following is an example of the GI 275 Main EIS page.

Figure F-1 Example Main EIS Page

Top Full-Time Gauges
The GI 275 EIS provides a section at the top to display specific gauge information on all pages. This
includes RPM and Manifold Pressure (if applicable). Additionally, a Prop Sync Wheel (conventional twin-
engine only) or Percent Power can be configured to be displayed.
Percent Power requires the following gauge inputs: RPM, Manifold Pressure, Fuel Flow, and OAT, as well
as inputting the Max Rated Horsepower, Max MAP, RPM at Max HP, and the Minimum Brake Specific
Fuel Consumption (BSFC). Refer to Section 5.6.1 for engine configuration settings.
The Manifold Pressure gauge can be configured to show on the left side or on the right side of the RPM
gauge. Refer to Figure F-2 for examples.

Figure F-2 Top Full-Time Gauge Examples

Bottom Full-Time Fuel Gauges
The GI 275 EIS provides a section at the bottom to display specific gauge information on all pages. If Main
Fuel is configured, the Main Fuel Quantity beakers will be shown on every page in the bottom center
(single or Left/Right). If Fuel Quantity is not configured, Outside Air Temperature will be displayed in this
location. If Fuel Quantity and OAT are not configured, Time (UTC) will be displayed full-time in the
bottom center position.
190-02246-10 GI 275 Part 23 AML STC Installation Manual
Rev. 11 Page F-2