Table 5-6 Nav Interfaces And Configuration Settings; Nav - Garmin GI 275 Installation Manual

5.4.7

NAV

Configure each GI 275 for a NAV source for NAV 1 or NAV 2 (if equipped) per the settings in Table 5-6.

Table 5-6 NAV Interfaces and Configuration Settings

NAV
Garmin GTN 650
Garmin GTN 650Xi
Garmin GTN 750
Garmin GTN 750Xi
Garmin GNS 430W/530W
Garmin GNS 480
Garmin GNC 255
Garmin SL 30
Collins VIR-32/33
Honeywell KN-53/KX-155/
KX-155A/KX-165/KX-165A
NAV from other GI 275
G500/G600 TXi
Notes:
[1] If Course Selection is disabled, configure CRS A429 port and speed.
[2] Disabling the Transmit Selected Course to the GTN configuration setting will prevent the course
selected on the GI 275 from crossfilling to the GTN 6XX/7XX or GTN Xi. Disable this setting when
the GI 275 has Course Selection enabled but is not the primary HSI/CDI interfaced to the GTN.
Course Selection
Disabling Course Selection allows the GI 275 to slave to the Selected Course from an external source. Set
the Course Selection to Disabled when an external system is providing the primary Selected Course data.
Set the Course Selection to Enabled when the GI 275 is the primary source for selected course data. The
Pilot Control configuration setting for Course Selection is not currently approved under this STC.
190-02246-10
Rev. 11
Interface
GTN 650
GTN 750
GNS 430/530 A429 IN
GNS 480 A429 IN
GNC 255 RS-232 RX/TX
SL 30 RS-232 RX/TX
Composite ILS Energize
Other GI 275
GX00 TXi
Ports/Config - Settings
Port Number
1 Thru 4
1 Thru 4
1 Thru 2
1 Thru 2
Discrete In
1 Thru 4
Lo
GI 275 Part 23 AML STC Installation Manual
Notes
Speed
[1] [2]
[1] [2]
[1]
Low
[1]
Low
[1]
[1]
Page 5-16