Garmin GI 275 Installation Manual page 364

NOTES CONTINUED
14
HARNESS BUILDUP PROCEDURE
1. BUILD RESISTOR ASSEMBLIES AS SHOWN IN NOTE 18.
2. COMPLETE RESISTOR ASSEMBLY AS SHOWN IN ABOVE FIGURE (I.E. CRIMP CONTACTS TO WIRES, TERMINATE SHIELD, ETC.).
2.1. REFERENCE FIGURE B-8 SHEET 4 FOR COMPLETE FUEL QUANTITY WIRING CONNECTIONS.
3. SEE NOTE 18 FOR CABLE TIE PLACEMENT TO AVOID COMPONENT STRAIN.
USE EITHER GP 6/MISC TEMP 1 OR GP 7/MISC TEMP 2 PORTS FOR TIT, CDT, IAT, OAT, AND PRIMARY EGT
15
SENSORS. CARB TEMP SENSOR MUST BE CONNECTED TO GP 6/MISC TEMP 1.
WHEN USING THE DUAL 2.2K RESISTOR WIRING CONFIGURATION SHOWN IN THIS FIGURE, THE
RESISTIVE FUEL PROBE MUST BE CONFIGURED AS A 0-5 VOLT SENSOR. THE RESISTIVE SENSOR
16
CONFIGURATION MUST NOT BE USED. REFER TO APPENDIX C.
SPLICE OF THE +12V OUTPUT IS ONLY REQUIRED FOR INSTALLATIONS INTERFACING TO TWO AUX TANKS
WITH RESISTIVE PROBES.
17
HARNESS BUILDUP PROCEDURE
1. BUILD RESISTOR ASSEMBLIES AS SHOWN IN NOTE 18.
2. COMPLETE RESISTOR ASSEMBLY AS SHOWN IN ABOVE FIGURE (I.E. CRIMP CONTACTS TO WIRES, TERMINATE SHIELD, ETC.).
2.1. REFERENCE FIGURE B-8 SHEET 4 FOR COMPLETE FUEL QUANTITY WIRING CONNECTIONS.
3. SEE NOTE 18 FOR CABLE TIE PLACEMENT TO AVOID COMPONENT STRAIN.
THE WIRING SUPPLIED WITH THE GTP 59 MAY BE EXTENDED IF THE SUPPLIED WIRE LENGTH IS NOT
18
SUFFICIENT FOR A PARTICULAR INSTALLATION.
190-02246-10
Rev. 11
CONTACT
(P/O GEA24 CONNECTOR KIT)
CONTACT
(P/O GEA24 CONNECTOR KIT)
RING TERMINAL
BRAID MAX 4 INCH
Figure B-8 GEA 24 Sensor Interconnect
Sheet 6 of 7
RESISTOR
RING TERMINAL
BRAID MAX 4 INCH
JUMPER (22 AWG)
1.75(+0.25/-0) INCH
RESISTOR
JUMPER (22 AWG)
RESISTOR
1.75(+0.25/-0) INCH
SOLDER SLEEVE (REF SECTION 4)
GI 275 Part 23 AML STC Installation Manual
JUMPER (22 AWG)
1.75(+0.25/-0) INCH
SOLDER SLEEVE (REF SECTION 4)
JUMPER (22 AWG)
1.75(+0.25/-0) INCH
SOLDER SLEEVE (REF SECTION 4)
BRAID MAX 4 INCH
RING TERMINAL
Page B-19