Cht/Egt Page - Garmin GI 275 Installation Manual

F.3 CHT/EGT Page
The CHT/EGT page is dedicated to CHT and EGT information, as well as Primary EGT or TIT, if
applicable. Similarly to the Main EIS and AUX EIS pages, the top section displays full-time gauges and
the bottom center area displays fuel quantity.
The bar graph on the CHT/EGT page will populate with 4 or 6 pairs (depending on engine configuration)
of CHT and EGT bars for each cylinder. If TIT sensors are installed and configured on the GI 275, then
one or two (depending on configuration) bars for TIT will be displayed on the right-hand side of the CHT/
EGT page. Alternatively, if a Primary EGT sensor is installed and configured, a bar for Primary EGT will
be displayed on the right-hand side of the CHT/EGT page. There is also a space below the CHT/EGT bar
graph where Fuel Flow is displayed, if installed and configured.
Figure F-11 CHT/EGT Page Examples
The CHT/EGT page can be cycled through three different modes that change display aspects of the CHT/
EGT bar graph for different pilot operations, such as Lean Assist or viewing cylinders in Normalized
layout during cruise.
190-02246-10 GI 275 Part 23 AML STC Installation Manual
Rev. 11 Page F-8