5.5 Setup
This section describes the setup for airframe, lighting, page configuration, sensors, audio alerts, Terrain/
TAWS, backup battery, and other miscellaneous settings. Ensure all interfaces necessary in Section 5.4
have been successfully configured prior to continuing with setup. Some pages contained in this section
may not be applicable to every installation or may not be available.
5.5.1
Airframe Configuration
The vertical speed, altitude, and airspeed units must be configured to match the instruments currently
installed in the airplane and designated in the POH/AFM.
Figure 5-5 Airframe Config Page
Roll Pointer
Configures pointer direction. Configure as Fixed (down) or Sky (up) per the POH/AFM.
The Roll Pointer setting must be configured to match the installed ADI. The attitude indicator on the
Primary ADI includes two pointers (on the Roll Pointer). When banking, one pointer indicates the aircraft
bank angle and the other pointer remains stationary. The pointer that indicates bank angle can either point
up (sky pointer) or down (fixed pointer).
ADI Style
Configures the layout of the ADI. Choose between Basic, 3-in-1, or 4-in-1. If Basic is selected, the
following settings are not available.
Basic
3-in-1
4-in-1
Figure 5-6 ADI Styles
190-02246-10
GI 275 Part 23 AML STC Installation Manual
Rev. 11
Page 5-34