Config Options - Garmin GI 275 Installation Manual

5.2.2

Config Options

5.2.2.1 GFC 500 Manifest
A GFC 500 Software Manifest diagnostic is provided on the GI 275 when interfaced with the GFC 500
system. This allows synchronization of GFC 500 LRU software versions upon a mismatch between the
systems. Refer to the GFC 500 STC for approval and interface information.
5.2.2.2 Summary
A configuration summary can be saved to a USB drive by touching the Save Summary button. The file
will detail configuration settings for all GI 275s in the system and can be viewed on a computer web
browser.
NOTE
Files will be saved to a "aircraft_cfg" folder on the USB drive.
5.2.2.3 Import Configuration
Configuration settings can be imported via USB using the following procedure:
1. Power on the GI 275 and all LRUs in the system in Configuration mode.
NOTE
Unit ID must be set before importing configuration. Refer to Section 5.3.1.
2. Insert the USB drive containing the configuration files into the USB dongle or GSB 15 (if
installed).
3. Navigate to SW/Config → Config Options.
4. Touch the Import Configuration button.
5. Touch the Select Files button and select the configuration file to be imported.
6. Touch the Select Configuration button.
7. Select the applicable configurations and then touch the Back button.
8. Touch the Import Config ( ) button and then touch the Start button.
5.2.2.4 Export Config
Configuration settings can be exported via USB using the following procedure:
1. Power the GI 275 and all LRUs in the system on in Configuration mode.
2. Insert a USB drive into the USB dongle or GSB 15 (if installed).
3. Navigate to SW/Config → Config Options.
4. Touch the Export Configuration button.
5. Touch the Select Name button and enter a name for the saved file.
6. Touch the Export Config button.
NOTE
Files will be saved to a "aircraft_cfg" folder on the USB drive.
190-02246-10
Rev. 11
GI 275 Part 23 AML STC Installation Manual
Page 5-6