Garmin GI 275 Installation Manual page 485

WSK "PZL-MIELEC"
OBR
A68EU (WSK PZL MIELEC
and OBR SK MIELEC)
[PZL]
Zenair
TA5CH
(Zenair Ltd.)
ZLIN Aircraft a.s.
A76EU (ZLIN Aircraft a.s.)
[MORAVAN a.s.]
ZLIN Aircraft a.s.
(ZLIN Aircraft a.s.)
A30EU
[Moravan National
Corporation]
Notes:
[1] The GTP 59 cannot be installed on Zone 2A composite areas.
[2] The GTP 59 must be bonded to the aluminum skin. For details, refer to Section 4.6.2.
[3] The GTP 59 must be bonded to the metallic tube structure. For details, refer to Section 4.6.2.
[4] The GTP 59 must be isolated from the aircraft ground plane. For details, refer to Section 4.6.2.
[5] The GMU 44B must be bonded to the aircraft ground plane. For details, refer to Section 4.6.1.
[6] The GMU 44B must be isolated from the aircraft ground plane. For details, refer to Section 4.6.1.
[7] The GMU 44B/GMU 11 may be mounted in the wingtip provided that certain criteria are met. For details, refer to Section 4.6.1.
[8] Nonmetallic aircraft.
[9] Reserved.
[10] Reserved.
[11] Remote LRUs must be installed on existing structure designated by aircraft manufacturer for avionics installation.
[12] For wing lightning zones, equipment installation only allowed in aluminum wings. Equipment installation is NOT allowed in wooden wings.
[13] Wires must be routed behind metallic substructure (i.e., routed behind instrument panel/pedestal/circuit breaker panel, along lightning ground
bar/strip, inside lightning ground tube, or along other airframe ground plane).
190-02246-10
Rev. 11
PZL M20 03
CH2000
Z-242L, Z-143L
ZLIN 526L
Figure G-3,
X Figure G-10 Figure G-18
Figure G-5
Figure G-3,
Figure G-6 Figure G-18
Figure G-5
Figure G-3,
Figure G-6 Figure G-18
Figure G-5
Figure G-3,
Figure G-6 Figure G-18
Figure G-5
Zone 2A, Zone 2A,
[1] [2] [5] [7]
Zone 3 Zone 3
Zone 2A, Zone 2A,
[1] [2] [5] [7]
Zone 3 Zone 3
Zone 2A, Zone 2A,
[1] [2] [5] [7]
Zone 3 Zone 3
Zone 2A, Zone 2A,
[1] [3] [5] [8]
Zone 3 Zone 3
GI 275 Part 23 AML STC Installation Manual
Page D-42