Vhf Navigation Receiver; Table C-6 Compatible Vhf Navigation Receiver - Garmin GI 275 Installation Manual

C.5 VHF Navigation Receiver
The VHF navigation receivers listed in Table C-6 are compatible with the GI 275. For a list of analog navigation receivers compatible with the GI 275, refer to
Appendix Section C.6.
Mfr Model
Other GI 275
GNC 255
Garmin
GNS 430W/430AW
GNS 530W/530AW
GNS 480 (CNX80)
GTN 650
GTN 750
GTN 650Xi
GTN 750Xi
190-02246-10
Rev. 11

Table C-6 Compatible VHF Navigation Receiver

Data Format Interfacing Equipment Configuration Information
HSDB
Serial Port page
RS-232
CDI Indicator page
VOR/LOC/GS
ARINC 429 ARINC 429 Config
page
ARINC 429 Setup
ARINC 429
page
HSDB Port
HSDB
Utilization page
HSDB Port
HSDB
Utilization page
IO MODE: NMEA
When GI 275 NAV CDI is desired to be driven by
a "standard CDI" connected to the GNC 255, set
TYPE: RESOLVER.
When GI 275 NAV CDI is desired to be set via the
GI 275 interface, set TYPE: SERIAL.
When GI 275 NAV CDI is desired to be set via the
GI 275 interface and/or the GNC 255 display, set
TYPE: NONE.
SPEED: TX: Low
SDI: VOR/ILS 1 (for NAV 1)
VOR/ILS 2 (for NAV 2)
CH OUT 2: SEL: VOR/ILS
SPEED: Low
SDI: Sys 1 (for NAV 1)
Sys 2 (for NAV 2)
Ethernet Port ( ): Connected
Ethernet Port ( ): Connected
Notes
Crossfills data from a different
GI 275 interfaced to a NAV
source.
Can be NAV 1, NAV 2, or both.
Can be NAV 1, NAV 2, or both.
Can be NAV 1, NAV 2, or both.
Software v6.70 or later required.
Can be NAV 1, NAV 2, or both.
Software v20.10 or later
required.
Can be NAV 1, NAV 2, or both.
GI 275 Part 23 AML STC Installation Manual
Page C-8