Leadshine iSV2-RS Series User Manual page 4

Tuning and running
 Make sure the wirings of servo drive and servo motor are installed and fixed properly before
powering on.
 On the first time tuning of the product, it is recommended to run unloaded until all the parameter
settings are confirmed to prevent any damage to the product or machine.
Usage
 Please install an emergency stop button on machine to stop operation immediately if there is an
accident.
 Please make sure machine is stopped before clearing an alarm.
 Servo drive must be matched with specified motor.
 Frequent restart of the servo system might incur damage to the product.
 Servo drive and motor will be hot to touch shortly after power off. Please be careful.
 Modification(s) to servo system is prohibited.
Error Handling
 Please wait for 5 minutes after powering off for the electricity to be fully discharged before
uninstalling the cables.
 Participate maintenance personals should have sufficient training in maintenance and operation
of this product series.
 Please handle the error before clearing an alarm.
 Keep away from machine after a restart upon alarm. Mechanical axis might suddenly move. Such
hazard should be prevented during the utilization of the product.
Model Selection
 Rated torque of the servo motor should be higher than continuous designated torque when fully
loaded.
 Load inertia ratio of the motor should be lower or equals to recommended value for specified
models
 Servo drive must be matched with specified motor.
User Manual of iSV2-RS Integrated Servo
!
Caution
Caution
!
Caution
Caution
!
Warning
Warning
!
Caution
Caution
!
Caution
Caution
4