Dürkopp Adler D869 e-con Operating Instructions Manual page 130

Icon Parameter
Needle position
Position of the needle when sewing
stops.
Sewing foot lift at stop
Height of sewing foot lift at
Sewing stop
Backwards
When the parameter is activated,
the section is sewn backwards.
Seam Center Guide
(only on 2-needle machines, optional
additional equipment)
Puller
(optional additional equipment)
The puller supports the transport of the
sewing material. The feed of the two
rollers is calculated automatically
based on the stitch length of the
machine. An adjustment may be nec-
essary depending on the application.
The rollers of the puller can be
adjusted separately. The input is in
percent: a positive value increases
the roller feed while a negative value
reduces the feed.
Gap
(optional additional equipment)
The edge guide helps to precisely
position the sewing material. The value
set indicates the distance between the
needle and edge guide/material edge.
128
Programming Commander DELTA
Setting
Value range
On/Off
Value range
On/Off
Value range
00 – 20 [mm]
(depending on subclass)
Value range
On/Off
Value range
On/Off
On/Off
Correction top roller
Value range
-100 – 100 [%]
Correction bottom roller
Value range
-100 – 100 [%]
Value range
01.0 - 45.0 [mm]
Operating Instructions D869 e-con - 00.0 - 06/2023