Dürkopp Adler D869 e-con Operating Instructions Manual page 186

Code Type
1004 Error
1005 Error
1006 Error
1007 Error
1008 Error
1010 Error
1011 Error
1012 Error
1054 Error
1055 Error
1060 Error
184
Possible cause
Incorrect sewing motor
direction of rotation
Motor blocked
Maximum speed exceeded
Error in the reference run
Sewing motor encoder error • Replace encoder
External synchronizer
plug (Sub-D, 9-pin) not
connected
Encoder Z pulse missing
Synchronizer fault
Internal short circuit
Sewing motor overload
Sewing motor overload /
overvoltage /overcurrent
Remedial action
• Replace encoder
• Check motor plug assignment and
change it if necessary
• Check wiring in machine distributor and
change it, if necessary
• Test motor phases and check for correct
value
• Check for stiff movement
• Replace encoder
• Replace sewing motor
• Replace encoder
• Perform reset
• Check class (t 51 04)
• Replace encoder
• Check for stiff movement
• Connect cable of external synchronizer to
control, make sure that interface (Sync) is
correct
• Only recommended for machines with
transmission!
• Switch off the control, use handwheel to
turn, and switch on the control again
• If error is not corrected, check encoder
• Replace synchronizer
• Replace control
• Check for stiff movement
• Replace encoder
• Replace sewing motor
• Check selection of class
• Replace control
• Replace motor
• Replace encoder
Operating Instructions D869 e-con - 00.0 - 06/2023
Troubleshooting