Dürkopp Adler D869 e-con Operating Instructions Manual page 116

114
5.8.5.1 Setting the Bobbin monitor mode parameters
The amount of remaining thread on the bobbin can be monitored
optically or by software using this setting.
Menu item
Off
Monitor
Monitor mode can
only be used if
the additional equip-
ment of the remain-
ing thread monitor
is present on the
machine. Monitor
mode allows for opti-
cal monitoring of the
bobbin.
Programming Commander DELTA
Setting 1
Sewing stop
Sewing stops and a notice is
shown on the display when
the bobbin is detected to be
nearly empty. If the parameter
is not activated, only the
LEDs on the machine arm
give a warning if the bobbin
is empty.
Sewing foot lower
position
t Clean
Duration for which the lens is
blown clear with compressed
air. The process takes place
as the thread is cut.
Operating Instructions D869 e-con - 00.0 - 06/2023
Setting 2
Value range
On/Off
Value range
On/Off
Value range
0000 – 5000 [ms]