Dürkopp Adler D869 e-con Operating Instructions Manual page 189

Troubleshooting
Code Type
2183 Error
2184 Error
2185 Error
2187 Error
2188 Error
2201 Error
2205 Error
2221 Error
2222 Error
2230 Error
2231 Error
2252 Error
2271 Error
Operating Instructions D869 e-con - 00.0 - 06/2023
Possible cause
Stepper motor card X30
overcurrent (Stitch length)
Stepper motor card X30
parameter init (Stitch length)
Stepper motor card X30
insulation error
(Stitch length)
Stepper motor card X30
transport interval
failure(Stitch length)
Stepper motor card X30
Reference drive failure
(Stitch length)
Stepper motor X40
reference run timeout
Stepper motor card X40
stepper motor blockage
Stepper motor card X40
encoder plug (Sub-D, 9-pin)
not connected
Stepper motor card X40
flywheel position not found
Stepper motor card X40 not
responding
Stepper motor card X40
parameter init error
Stepper motor card X40
overcurrent
Stepper motor card X40
Watchdog (sewing foot lift)
Remedial action
• Replace control
• Perform a software update
• Check selection of class
• Check motor phase and PE for low-
impedance connection
• Replace encoder
• Replace sewing motor
• Perform a software update
• Check selection of class
• Check for stiff movement
• Replace encoder
• Replace motor
• Check reference sensor
• Check for stiff movement
• Connect encoder cable to the control, use
the correct interface
• Check stepper motor 1 for stiff movement
• Perform a software update
• Replace control
• Perform a software update
• Check selection of class
• Check for stiff movement
• Perform a software update
• Check selection of class
187