Dürkopp Adler D869 e-con Operating Instructions Manual page 51

Operation
Operating Instructions D869 e-con - 00.0 - 06/2023
Condition Processes
At seam beginning
Start bartack • Press the pedal forwards (position +1) and keep it
and sew there.
Machine sews a start bartack (if specified).
Afterwards, the machine continues to sew - with
increasing speed the further forward the pedal is
pressed.
In the middle of the seam
Stop sewing • Release the pedal (position 0).
Machine stops. Depending on the setting, sewing
feet and needle are up / down.
Continue • Press the pedal forwards (position +1)
the sewing Machine continues to sew - with increasing speed
process (after the further forward the pedal is pressed.
releasing the
pedal)
Sew over • Switch on the elevated sewing foot stroke with the
thicker parts of knee button ( p. 45).
the material
Change the
• Activate the 2
stitch length
push button panel ( p. 45).
Increase the • Activate additional thread tension using the button on
thread tension the push button panel ( p. 45).
Sew an • Sew backwards with stitch regulator ( p. 44) or
intermediate activate backwards sewing using the button on the
bartack push button panel ( p. 45).
At seam end
Finish the • Press the pedal fully back (position -2) and keep it
seam and there.
remove End bartack is sewn, and thread is cut (if set).
the sewing Machine stops.
material Needle up, sewing feet down.
• Remove the sewing material.
nd
stitch length using the button on the
49