Dürkopp Adler D869 e-con Operating Instructions Manual page 113

Programming Commander DELTA
Icon Parameter
Gap (2
The 2
switched on using a button on the push
button panel or the tile on the control
panel.
Program Cycle
Next program
A subsequent program can be defined.
Input via program number.
Program Cycle
The program is executed as a loop,
which is useful, for instance, for orna-
mental stitch seams.
You select the start segment and the
end segment from a program and
define how often you wish the selected
segments to be sewn.
Main Parameter
Needle thread clamp
The needle thread clamp is closed at
the 1
the needle thread lies on the underside
of the sewing material
Bobbin monitor mode
Operating Instructions D869 e-con - 00.0 - 06/2023
nd
value)
nd
value for the gap can be
st
stitch of the seam to ensure that
Setting
Value range
01.0 – 45.0 [mm]
On/Off
Start Segment
Value range 00 – 30
(0 = the cycle starts with the first
segment)
End Segment
Value range 00 – 30
(0 = the cycle ends with the last
segment)
Repetitions
Value range 00 – 99
(0 = the cycle continues until the next
segment is activated manually)
Value range
On/Off
(see  p. 114)
111