Dürkopp Adler D869 e-con Operating Instructions Manual page 92

90
5.6.3.3 Setting the Material thickness detection
parameters
To achieve consistently good sewing results for different material
thicknesses, some parameters can be adjusted specifically to the
material thickness.
Overview of settings modes
The material thickness can be identified in various modes and
responded to depending on the setting. This general explanation
can be applied to the following specific parameters.
Setting mode Description
In the linear setting, the size of the parameter
linear
increases or decreases steadily as the material thick-
ness increases. The increase/decrease of the param-
eter depends on the limits set for the minimum and
the maximum material thickness.
If a certain material thickness is exceeded, the
2.OnOff
nd
2
thickness then falls below this level again, it switches
to the base value for the parameter.
If a certain material thickness is exceeded, the
2.On
nd
2
thickness then falls below this level again, it does
NOT switch to the base value for the parameter.
Only after finishing the seam by cutting the thread
is the base value for the parameter set again.
Programming Commander DELTA
value of the parameter is activated. If the material
value of the parameter is activated. If the material
Operating Instructions D869 e-con - 00.0 - 06/2023