Table of Contents
Advertisement
Programming Commander DELTA
Operating Instructions D869 e-con - 00.0 - 06/2023
Menu item
Software /
Stitch Counter
In Software mode,
the bobbin is moni-
tored by the software
based on the num-
ber of stitches sewn.
Setting 1
Counter Type
4 different counters can be
applied. The following 3 sub-
items can be set for each of
the counters.
Counter value
Bobbin supply capacity in
stitches. This is a very vari-
able value, which depends on
the size of the bobbin and the
thickness of the thread.
Sewing stop
Sewing stops and a notice is
shown on the display when
the bobbin is detected to be
nearly empty. If the parameter
is not activated, only the
LEDs on the machine arm
give a warning if the bobbin is
empty.
Sewing foot lower
position
Reset necessary
It is only possible to resume
sewing after changing the
bobbin and confirming the
message on the control
panel.
Setting 2
Value range
A/B/C/D
Value range
00000 - 99999
Value range
On/Off
Value range
On/Off
Value range
On/Off
115
Advertisement
Table of Contents
