Table of Contents
Advertisement
Code
Type
9910
Warning
9911
Warning
9912
Warning
9913
Warning
9914
Warning
9915
Warning
9916
Warning
9917
Warning
9918
Warning
9919
Warning
9920
Warning
9921
Warning
9922
Warning
9923
Warning
9924
Warning
9925
Warning
9926
Warning
9927
Warning
9928
Warning
9929
Warning
202
Possible cause
Sewing stop
Power down
Restart necessary
Empty bobbin
Reset
Please Wait!
Erase internal Memory
Erase USB key
No USB key present
Sewing stop
Referencing
Show Message from
QONDAC
Service Stop
Update required
Security key generated
Security Key changed!
Please Confirm Reset
Reset
Referencing?
Not enough thread available • Please insert a full bobbin
Remedial action
• Check tilt sensor on machine
• Check 24V
• Replace control
• The control is switched off
• Switch off the control
• Please insert a full bobbin
• Remove USB key!
• Please wait and do not remove USB key
• Delete the SD card. Continue with OK;
cancel with ESC
• Delete the USB key. Continue with OK;
cancel with ESC
• Please insert USB key
• Machine in stop mode for threading the
thread
• Please wait for motor referencing
• Show Message
• Check the Service Stop button
• Check 24V
• Replace control
• Press OK for Restart or ESC for cancel
• Creation of a security key on a USB key
• Overwrite Security Key?
• Really reset?
• Reset successfully
• Press pedal backwards (pedal position-2)
Operating Instructions D869 e-con - 00.0 - 06/2023
Troubleshooting
Advertisement
Table of Contents
