Initializing Non-Volatile Information; Executing Either Command - Quantum P4000 User Manual

Initializing Non-Volatile Information

Executing Either
Command
4
4 When you have selected the type of test and all test options, press the
button.
Execute
A "Command In Progress" dialog box is displayed.
The system test continues until completed unless you press the
button. If you pressed the
press the button to stop the test.
Abort
The screen contains two commands involving information stored
Service
in nonvolatile memory:
Caution: The following two commands are meant to be used only
by qualified, Quantum-trained personnel. They are
presented here for explanation only. Serious operational
problems and data loss may occur if you do not fully
understand the consequences of these commands.
• Initialize nonvolatile memory configuration—returns the library
configuration to its factory-default condition, eliminating any
changes made using the Configure Library and Configure Options
commands in the Operator screen and invalidates the calibration
data.
• Initialize nonvolatile memory statistics—purges nonvolatile memory of
all statistical information about library operation. This information is
used to generate the statistical report described on
To execute either command:
1 On the screen, press the button that corresponds to the
Service
command you want to execute. The GUI displays a dialog box
prompting you to Continue or Cancel the command.
Quantum P4000 and P7000 Libraries User's Guide
Chapter 4 Service Commands
Initializing Non-Volatile Information
button in step 3, you must
Continuous
Abort
4
page 76.
83