Table of Contents
Advertisement
Initializing Non-Volatile Information
Select one of the following system test options:
2
•
Swap Bins - test storage bins only
Swap Drives - test drives only
•
Select all desired test options as follows:
3
•
Random - swap cartridges at random
Use Barcodes - read barcode as cartridges are swapped
•
Continuous - repeat test until aborted
•
Note: The Continuous button must be deselected to enter
"# of Runs".
When you have selected the type of test and all test options,
4
press the Execute button.
The GUI displays the Command In Progress dialog box.
The system test continues until completed unless you press the
Abort button. If you pressed the Continuous button in step 3,
you must press the Abort button to stop the test.
The Service screen contains two commands involving information
stored in nonvolatile memory:
Caution: The following two commands are meant to be used
only by qualified, ATL-trained personnel. They are
presented here for explanation only. Serious
operational problems and data loss may occur if you
do not fully understand the consequences of these
commands.
ATL P2000 Series Automated Tape Library User's Guide
Chapter 4 Service Commands
Initializing Non-Volatile Information
4
65
Advertisement
Table of Contents
