Connecting the Emulation Probe to a LAN
Connecting the Emulation Probe to a Site LAN
To configure LAN parameters using a logic analysis
system with an emulation module
1 Connect the emulation module to the emulation probe. (See page 45.)
2 Connect the LAN cable to the connector on the emulation probe.
3 Cycle power on the emulation probe by powering it off then on again.
4 Wait at least 20 seconds for the emulation probe to recognize the LAN.
5 From the E5901B emulation module icon, select Modify Interconnected
Probe LAN Addresses....
6 Select Read Probe Addresses to read the current settings.
7 Enter the internet address, gateway IP and subnet mask in the
appropriate fields.
8 Select OK.
9 Cycle power on the emulation probe. The new addresses will take
effect after you cycle power.
36
Emulation for the Motorola M•CORE