Troubleshooting the Emulation Probe
General Troubleshooting
Step 5: Check your debugger connection
If you are using a debugger, try connecting to the emulation probe.
If you have problems using the emulation probe
with a debugger
Most problems are associated with not having the emulation probe and target
properly configured or initialized.
Some debuggers have an initialization file that needs to be properly defined
before a debugger can connect to the emulation probe.
• Make sure the PC or workstation where the debugger is running can
ping the emulation probe. (See "Verifying LAN Communications" on
page 39.)
• Initialize the emulation probe and target so that the debugger can
connect. Refer to your debugger manual for proper initialization.
• Refer to your debugger manual for proper operation.
If you need to obtain help
If, after following the troubleshooting steps and looking through the other
sections in this chapter, the emulation probe still is not working:
1 Write down the target processor version, the emulation probe firmware
version, and the type of emulation probe (E5900B). See page 106 for
instructions on how to display the emulation probe firmware version.
2 Call your nearest Agilent Technologies sales or service office.
To locate a sales or service office near you, go to http://www.tm.agilent.com
and select Assistance.
128
Emulation for the Motorola M•CORE