Using the Emulation Probe Command Line
Interface
The emulation probe has some built-in commands (also called the "terminal
interface") which you can use for troubleshooting.
You can enter the built-in commands using:
• A telnet (LAN) connection (see page 132).
• The Command Line window in the Emulation Control Interface (see page
131).
• A "debugger command window" in your debugger (see your debugger
software instructions).
• A serial connection (see page 28).
To use the command line interface from the logic
analysis system
1 Connect to the emulator. See "Using the Emulation Control Interface"
on page 76 for step-by-step instructions.
2 From the Run Control menu bar select Window,
then select the emulator,
and select Command Line....
Emulation for the Motorola M•CORE
Troubleshooting the Emulation Probe
Using the Emulation Probe Command Line Interface
131