Agilent E5901B Emulation Module; Equipment Supplied; Minimum Equipment Required - Agilent Technologies E5900B User Manual

Overview

Agilent E5901B Emulation Module

Agilent E5901B Emulation Module

Equipment supplied

The equipment supplied with your emulation module includes:
• All of the parts listed for the Agilent E5900B emulation probe on
page 18 (except the serial cable and RJ12 to DB9 adapter).
• Agilent E5901B emulation module, which facilitates communication
between the Agilent 16700-series logic analysis system and the Agilent
E5900B emulation probe. If you ordered an emulation module as part of
your Agilent 16700-series logic analysis system, it is already installed in the
frame.
• Module/probe interconnect cable (connected to the emulation module).
• Firmware for the emulation probe and software for the Emulation Control
Interface on a CD-ROM.
• Torx T-10 and T-15 screwdrivers.
• LAN crossover cable (for point-to-point LAN connection only).

Minimum equipment required

The following equipment is required to use the emulation module:
• A method for connecting the emulation probe to the target system. The
target system must have an appropriate JTAG debug port connector. The
target system must meet the criteria on page 53.
• An Agilent 16700-series logic analysis system.
• A user interface, such as a high-level source debugger or the logic analysis
system's Emulation Control Interface.
20 Emulation for the Motorola M•CORE