Table of Contents
Advertisement
See Also
target flash memory."
To display the emulation probe firmware version
ver
Use the help command for more information on these and other commands.
Note that some of commands listed in the help screens are generic commands
for Agilent emulation probes and may not be available for your product.
If you are writing your own debugger, contact Agilent Technologies for more
information.
Emulation probe command line prompts
The prompt indicates the status of the emulation probe:
Emulation probe prompts
U>
Running user program
M>
Running in background monitor
p>
No target power
R>
Emulation reset
r>
Target reset
?>
Unknown state
->
Firmware is not properly communicating with the target
(Try running "init -p" immediately to correct this condition)
$
$ with any prompt indicates to a telnet user that the emulator is in
use by a debugger or a logic analysis system's Emulation Control
Interface
Emulation for the Motorola M•CORE
Troubleshooting the Emulation Probe
Using the Emulation Probe Command Line Interface
137
Advertisement
Table of Contents
Troubleshooting
