Is Your Debugger Compatible With The Emulation Probe; Lan Connection; Compatibility With The Emulation Control Interface; Connecting To An Emulation Module - Agilent Technologies E5900B User Manual

Using the Emulation Probe
Using the Emulation Probe with a Debugger

Is your debugger compatible with the emulation probe?

Ask your debugger vendor whether the debugger can be used with an Agilent
emulation module or emulation probe.

LAN connection

You will use a LAN connection to allow the debugger to communicate with the
emulation probe. This is described in Chapter 2, "Connecting the Emulation
Probe to a LAN," beginning on page 25.

Compatibility with the Emulation Control Interface

Do not use the logic analysis system's Emulation Control Interface and your
debugger at the same time.

Connecting to an Emulation Module

If you are using an E5901B emulation module, configure your debugger to use
the IP address of the E5900B emulation probe, not the logic analysis system.
You may need to tell the debugger which port number to use. The default port
number for a debugger connection is 6470.
Do not use the Emulation Control Interface at the same time as a debugger.
80 Emulation for the Motorola M•CORE