Agilent Technologies E5900B User Manual page 60

4 Plug the keyed end of the cable (pin 8 is blocked) into the JTAG debug
CAUTION:
5 Turn on power to the emulation probe.
6 Turn on power to the target system.
See Also
Connecting the Emulation Probe to Your Target System
To connect the emulation probe to the target system
port on the target system.
Be sure to orient the connector correctly. If the connector is rotated, your
target system or the emulation probe may be damaged.
After you have connected the emulation probe to your target system, you may
need to update the firmware in the emulation probe.
For information on designing a debug port on your target board, see page 53.
For a list of the parts supplied with the emulation probe, see page 18.
60 Emulation for the Motorola M•CORE